A filler of lime consists of a load(responsibility) and a sociable disposition mixed with some water to obtain a smooth dough, which applies to an outside or internal support structured by reliefs and by harshness (stony wall, bricks, rubble stones) The filler in the lime levels the surface in the insulation of the cold and the humidity while letting inhale the support. The filler in the lime applies by projection, lisseuse or trowel, allowing ornamental colored finishes smoothed or scratched in wills of your requirements. The lime is a sociable disposition stemming from some limestone, thus white. The filler in the lime can be thus never of very lively colour. He(it) offers on the other hand a very vast range of sweet and average colours. The aspect is more rustic than that of the stucco, and calls back(reminds) the walls of the Provençal houses. The lime has many properties, notably that of heat insulator and phonique.

Working process of the filler of lime

In a bétonniére overturn into the following order: the water, the sand, the marble flour, the lime and "Predose", to mix then to add pigments, to mix again without addition of water.
Supports are cleaned and prepared by means of a brush, for the former(ancient) walls, to prick the joints of existing mortars.
Moisten in saturation the support.
Premiére pass in pier of trowel.
To level the premiére passes.
Implementation of the high and low repéres of wished thickness.
Between repéres apply the filler to finished load(responsibility) which will serve as guide for the régle.
Fill by pier of trowel the filler between repéres.
Applanissement in the régle to remove the excés of load(responsibility) between repéres.
Moisten légérement the wall.
Talocher finely for a filler in the lime final, or more grossiérement if he has to be of use as support to a stucco, a to distemper (in that case the tint(coloring) of the filler of lime is superfluous).